Latest Products

  • Inverter Charger Top

3000W and 35A Low Frequency Pure Sine Wave Inverter Charger

A Long lasting, powerful and efficient inverter with a built in 35A Charger
$799CAD
Qty:
Print
Inverter

This is a 3000W inverter with a 9000W peak. Has a universal outlet that accepts plugs from North America, Europe or UK. Also has a DIY AC terminal for you to wire in AC to your own distribution block. Has an automatic, built-in transfer switch for seamless transition between line power and battery inverter mode to not interrupt any of your devices. This device is a LOW frequency inverter, having the advantages of more reliability and higher peak output.

Charger

When the device is connected to shore or line power, it will use line power to charge your battery at up to 35A. It is compatible with all battery types including AGM, SLA, GEL, Lithium-ion (including LiFePO4) or your own custom battery packs.


MODEL
FT-302
RATED POWER
3KW
SURGE POWER
9KW
INPUT
VOLTAGE
120VAC
FREQUENCY RANGE
60HZ±5HZ
OUTPUT
AC VOLTAGE REGULATION(BATT. MODE)
(DC BATT.MODE)120VAC±3%
TRANSFER TIME
≤5ms
WAVE FORM
PURE SINE WAVE
BATTERY
BATTERY VOLTAGE
12V
FLOATING CHARGE VOLTAGE
13.8V(12V)
OVERCHARGE PROTECTION
17V(12V)
AC CHARGER
STANDBY POWER COMSUMPTION
15W
MAXIMUM AC CHARGE CURRENT
35A
PHYSICAL
DIMENSION,D*W*H(MM)
530*335*250MM
G.W.(KGS)
26.8
ENVIRONMENT
HUMIDITY
0~95%（NO CONDESNSATION)
OPERATING TEMPERATURE
0~60℃
STORAGE TEMPERATURE
0~60℃

Modes of Operation:
Line priority mode - Prioritizes Shore power as the main supplier of power, it will charge, and pass through shore power to the outlets whenever there is shore power. This mode assumes you have unlimited shore power so it does not have a low voltage cut off, though your batteries inbuilt bms's should have this cut off regardless.
Battery mode - Uses BATTERIES as the priority, will not charge the batteries even when there is shore power. Generally won't use this unless you are purposely trying to discharge your batteries. Can set low voltage cut off and low voltage restore here, the default settings of 10.5v and 12.5v is fine, but can also adjust a little lower to 10v and 12v.
Eco mode - This cycles the inverter side of the unit on and off every 10 secs, uses very little power. Every ON cycle, it will check if there are any loads on the AC output, if there is a load about 150W, the inverter will stay on. If there is not, the inverter will keep cycling. Take note of this threshold as LED lights will not keep the inverter on. This mode charges as well.
Unattended Mode - Tries to balance everything, uses AC shore power as a priority, charges batteries when on shore power. Can set low voltage cut off and low voltage restore here, the default settings of 10.5v and 12.5v is fine, but can also adjust a little lower to 10v and 12v.
Generator mode - is the same as line power mode but more accepting of choppier sine waves. 

UL Listed - UL 1741

1 Year Manufacturer Warranty